A New Technology on Liquid Forging of Thin Wall Pieces

Ren Xueping; Chu Yuanzhang

doi:10.13374/j.issn1001-053x.1993.03.026

Volume 15 Issue 3

Oct. 2021

Turn off MathJax

Article Contents

Article Navigation > Chinese Journal of Engineering > 1993 > 15(3): 281-286

Ren Xueping, Chu Yuanzhang. A New Technology on Liquid Forging of Thin Wall Pieces[J]. Chinese Journal of Engineering, 1993, 15(3): 281-286. doi: 10.13374/j.issn1001-053x.1993.03.026

Citation:

Ren Xueping, Chu Yuanzhang. A New Technology on Liquid Forging of Thin Wall Pieces[J]. Chinese Journal of Engineering, 1993, 15(3): 281-286. doi: 10.13374/j.issn1001-053x.1993.03.026

Ren Xueping, Chu Yuanzhang. A New Technology on Liquid Forging of Thin Wall Pieces[J]. Chinese Journal of Engineering, 1993, 15(3): 281-286. doi: 10.13374/j.issn1001-053x.1993.03.026

Citation:

Ren Xueping, Chu Yuanzhang. A New Technology on Liquid Forging of Thin Wall Pieces[J]. Chinese Journal of Engineering, 1993, 15(3): 281-286. doi: 10.13374/j.issn1001-053x.1993.03.026

PDF( 576 KB)

A New Technology on Liquid Forging of Thin Wall Pieces

doi: 10.13374/j.issn1001-053x.1993.03.026

Department of Metal Forming

Received Date: 1992-02-17
Available Online: 2021-10-18

Abstract

Abstract

Liquid forging processing to thin wall waveguide angle head has been experimentally studied. The results show that the dimensional tolerance of waveguide angle head by liquid forging processing are 0.02-0.04mm, it meets the requirements of standardization, building block system, built-up type and stability to waveguide parts. This new technology can increase high percentage of stock utilization and productivity efficiency, and lower cost.
- liquid forging,
- thin wall piece,
- waveguide angle head