A New Technology on Liquid Forging of Thin Wall Pieces
-
摘要: 本文對簿壁波導彎頭件的液態模鍛成形進行了研究。研究結果表明:液態模鍛波導彎頭件的尺寸精度在0.02mm~0.04mm之內,滿足波導器件的標準化、積木化、組合化和穩定化的要求。采用該項新技術,可以提高材料的利用率和生產效率,降低成本。Abstract: Liquid forging processing to thin wall waveguide angle head has been experimentally studied. The results show that the dimensional tolerance of waveguide angle head by liquid forging processing are 0.02-0.04mm, it meets the requirements of standardization, building block system, built-up type and stability to waveguide parts. This new technology can increase high percentage of stock utilization and productivity efficiency, and lower cost.
-
Key words:
- liquid forging /
- thin wall piece /
- waveguide angle head
-
點擊查看大圖
計量
- 文章訪問數: 257
- HTML全文瀏覽量: 85
- PDF下載量: 7
- 被引次數: 0
下載:
