銅尾礦流變特性與管道輸送阻力計算

楊超; 郭利杰; 張林; 胡黎明; 許文遠

doi:10.13374/j.issn2095-9389.2017.05.003

銅尾礦流變特性與管道輸送阻力計算

doi: 10.13374/j.issn2095-9389.2017.05.003

1) 北京礦冶研究總院, 北京 102628
2) 清華大學水沙科學與水利水電工程國家重點實驗室, 北京 100084

基金項目:

國家自然科學基金資助項目（51579132）；國家國際科技合作專項資助項目（2014DFR70340）

詳細信息

中圖分類號: TD50
計量
- 文章訪問數: 770
- HTML全文瀏覽量: 275
- PDF下載量: 26
- 被引次數: 0
出版歷程
- 收稿日期: 2016-07-20

Study of the rheological characteristics of copper tailings and calculation of resistance in pipeline transportation

1) Beijing General Research Institute of Mining & Metallurgy, Beijing 102628, China
2) State Key Laboratory of Hydroscience and Engineering, Tsinghua University, Beijing 100084, China

摘要

摘要: 流變參數是管道輸送系統設計的基礎，采用RST-SST型軟固體流變儀進行尾礦漿體流變特性試驗，確定了不同固相質量分數下尾礦漿體的屈服應力、黏度系數.當漿體固相質量分數大于70%后，屈服應力會隨著固相含量的增加而顯著上升.對礦漿進行剪切變稀試驗發現，屈服應力可下降40.9%.針對不同尾礦漿體開展標準坍落度試驗，當固相質量分數小于74%時，尾礦漿具有良好的流動性及較大的坍落度.利用得到的尾礦漿體的流變特性參數，進行了臨界流速、摩阻損失的計算，為尾礦管道輸送系統設計提供參考.
- 采礦工程 /
- 尾礦 /
- 流變特性 /
- 坍落度 /
- 摩阻損失
Abstract: Rheological characteristics are fundamental to pipeline system design. Rheological tests were conducted to obtain the yield stress and viscosity index at different mass fractions. Slump tests were conducted to investigate the mobility of tailings slurry. Results show that the yield stress increases with the increase of mass fraction, especially when mass fraction is greater than 70%. After stirring in a high-speed activation stirrer, the yield stress in 70% mass fraction is decreased by 40.9%. When the mass fractions are lower than 74%, high slump values are obtained. Based on the basic parameters obtained in the rheological tests, the key parameters of the pipeline system were calculated, including the critical flow rate and frictional resistance loss. These analyses results could serve as references for pipeline system design.
- mining engineering /
- tailings /
- rheological characteristic /
- slump test /
- frictional resistance loss

HTML全文

參考文獻(5)

[8]	Gawu S K Y, Fourie A B. Assessment of the modified slump test as a measure of the yield stress of high-density thickened tailings. Can Geotech J, 2004, 41(1):39
[13]	Belem T, Benzaazoua M. Design and application of underground mine paste backfill technology. Geotech Geol Eng, 2008, 26(2):147
[14]	Kwak M, James D F, Klein K A. Flow behaviour of tailings paste for surface disposal. Int J Miner Process, 2005, 77(3):139
[15]	Cooke R. Design procedure for hydraulic backfill distribution systems. J S Afr Inst Min Metall, 2001, 101(2):97
[16]	Ouellet S, Bussière B, Aubertin M, et al. Microstructural evolution of cemented paste backfill:mercury intrusion porosimetry test results. Cem Concr Res, 2007, 37(12):1654