底吹條件下電弧爐煉鋼熔池的流體流動特性

董凱; 魏光升; 常軍; 蘇榮芳; 吳學濤

doi:10.13374/j.issn2095-9389.2018.s1.014

底吹條件下電弧爐煉鋼熔池的流體流動特性

doi: 10.13374/j.issn2095-9389.2018.s1.014

董凱^1,2,
魏光升^1,2, ,,
常軍³,
蘇榮芳⁴,
吳學濤¹

1. 北京科技大學冶金與生態工程學院;
2. 北京科技大學高端金屬材料特種熔煉與制備北京市重點實驗室;
3. 西寧特殊鋼股份有限公司;
4. 北京榮誠京冶科技有限公司

基金項目:

國家自然科學基金資助項目 (51734003, 51474024, 51604022)

詳細信息

通訊作者:
魏光升, E-mail:wgshsteel@126.com

中圖分類號: TF741.5
計量
- 文章訪問數: 45
- HTML全文瀏覽量: 18
- PDF下載量: 3
- 被引次數: 0
出版歷程
- 收稿日期: 2018-01-18
- 網絡出版日期: 2023-07-18

Fluid flow characteristics of molten bath with bottom-blowing in EAF steelmaking

1. School of Metallurgical and Ecological Engineering,University of Science and Technology Beijing;
2. Beijing Key Laboratory of Research Center of Special Melting and Preparation of High-end Metal Materials,University of Science and Technology Beijing;
3. Xining Special Steel Co.Ltd.;
4. Beijing Rongcheng Jingye Science and Technology Co.Ltd.

摘要

摘要: 電弧爐煉鋼廣泛采用底吹技術以強化熔池攪拌、加速冶金反應和提升產品質量.本文通過數值模擬和水模型實驗研究了底吹條件下電弧爐煉鋼熔池內流體流動特性, 分析了底吹流股對流體流動的影響作用規律.隨底吹流量的增加, 熔池平均流動速度增加, 熔池內“死區”體積減小.同時結合工業生產實測數據, 發現電弧爐底吹技術的運用可通過強化熔池攪拌, 加快熔池內熱量傳遞, 均勻熔池鋼液溫度, 有效加快煉鋼熔池的熱量傳遞和整體升溫速率, 大大提高冶煉過程熱量的利用效率.
- 電弧爐 /
- 底吹 /
- 數值模擬 /
- 水模型實驗 /
- 熱傳遞
Abstract: Bottom-blowing technology is widely adopted in electric arc furnace (EAF) steelmaking to promote the molten bath fluid flow, accelerate the metallurgical reaction and improve the quality of molten steel.In this study, a water model experiment and a computational fluid dynamics (CFD) model were established to investigate the fluid flow characteristics of molten bath with bottom-blowing in EAF steelmaking process and the effects of bottom-blowing gas on the fluid flow were analyzed.Meanwhile, based on industrial application research, the heat transfer in the molten bath with bottom-blowing was analyzed.Compared with traditional smelting conditions without bottom-blowing, bottom-blowing technology can strengthen the stirring of the molten bath, promote the heating rate and the temperature homogeneity of the molten bath.Hence, bottom-blowing technology greatly improves the efficiency of energy utility in EAF steelmaking.
- electric arc furnace /
- bottom-blowing /
- numerical simulation /
- water model experiment /
- heat transfer

HTML全文

參考文獻(15)

[1]	Dong K, Zhu R, Liu W J, et al. Influencing factors of EAF offgas composition. J Univ Sci Technol Beijing, 2011, 33 (S1) :77 (董凱, 朱榮, 劉文娟, 等.電弧爐爐氣成分的影響因素.北京科技大學學報, 2011, 33 (S1) :77)
[2]	Li L F, Jiang M F, Duan Z Y. Simulation research on the rising height of the bath in bottom stirring EAF. Steelmaking, 1996, 12 (2) :49 (李連福, 姜茂發, 段振瀛.電弧爐底吹攪拌熔池表面突起高度的模擬研究.煉鋼, 1996, 12 (2) :49)
[3]	Ma G H, Zhu R, Liu R Z, et al. Research and application of electric arc furnace composite blowing technology. China Metall, 2013, 23 (12) :12 (馬國宏, 朱榮, 劉潤藻, 等.電弧爐煉鋼復合吹煉技術的研究及應用.中國冶金, 2013, 23 (12) :12)
[4]	Wang X Y, Zhu R, Li G F, et al. Process effect analysis of bottom stirring system for 90 t EAF. Ind Heat, 2013, 42 (2) :39 (王學義, 朱榮, 李國豐, 等. 90 t電弧爐底吹工藝效果分析.工業加熱, 2013, 42 (2) :39)
[5]	Wang H, Zhu R, Gu Y L, et al. Behaviours of supersonic oxygen jet injected from four-hole lance during top-blown converter steelmaking process. Can Metall Quart, 2014, 53 (3) :367
[6]	Li Z, Zhu R, Liu R, et al. Comparison of smelting effects by bottom blowing different gases. Iron Steel, 2016, 59 (9) :40
[7]	Liu F H, Zhu R, Dong K. Simulation and application of bottomblowing in electrical arc furnace steelmaking process. ISIJ Int, 2015, 55 (11) :2365
[8]	B. K. Li. Fluid flow and mixing process in a bottom stirring electrical arc furnace with multi-plug. ISIJ Int, 2009, 40 (9) :863
[9]	Dong K, Zhu R, Liu W J. Bottom-blown stirring technology application in consteel EAF. Adv Mater Res, 2012, 361-363:639
[10]	Cipolla J, Chan A H, Pawliska V. Experience of inert gas stirring in the EAF at Armco Butler. Iron Steelmaker, 1991, 18:27
[11]	He C L, Zhu R, Dong K, et al. Three-phase numerical simulation of oxygen penetration and decarburisation in EAF using injection system. Ironmaking Steelmaking, 2011, 38 (4) :291
[12]	Li Y, Lou W T, Zhu M Y. Numerical simulation of gas and liquid flow in steelmaking converter with top and bottom combined blowing. Ironmaking Steelmaking, 2013, 40 (7) :505
[13]	Hirt C W, Nichols B D. Volume of fluid (VOF) method for the dynamics of free boundaries. J Computational Phys, 1981, 39 (1) :201
[14]	Wei G, Zhu R, Dong K, et al. Research and analysis on the physical and chemical properties of molten bath with bottom-blowing in EAF steelmaking process. Metall Mater Trans B, 2016, 47:3066
[15]	He P. Analysis of physicochemical behavior in EAF bath with bottom-blowing. J Iron Steel Res, 1995, 7 (3) :16 (何平.底吹電弧爐熔池內物理化學行為分析.鋼鐵研究學報, 1995, 7 (3) :16)