Liquid Phase Sintered Molybdenum-Rich Copper Alloy

Li Xiaohong; Jie Zizhang; Yang Rang

doi:10.13374/j.issn1001-053x.1996.04.007

Volume 18 Issue 4

Nov. 2021

Turn off MathJax

Article Contents

Article Navigation > Chinese Journal of Engineering > 1996 > 18(4): 330-333

Li Xiaohong, Jie Zizhang, Yang Rang. Liquid Phase Sintered Molybdenum-Rich Copper Alloy[J]. Chinese Journal of Engineering, 1996, 18(4): 330-333. doi: 10.13374/j.issn1001-053x.1996.04.007

Citation:

Li Xiaohong, Jie Zizhang, Yang Rang. Liquid Phase Sintered Molybdenum-Rich Copper Alloy[J]. Chinese Journal of Engineering, 1996, 18(4): 330-333. doi: 10.13374/j.issn1001-053x.1996.04.007

Li Xiaohong, Jie Zizhang, Yang Rang. Liquid Phase Sintered Molybdenum-Rich Copper Alloy[J]. Chinese Journal of Engineering, 1996, 18(4): 330-333. doi: 10.13374/j.issn1001-053x.1996.04.007

Citation:

Li Xiaohong, Jie Zizhang, Yang Rang. Liquid Phase Sintered Molybdenum-Rich Copper Alloy[J]. Chinese Journal of Engineering, 1996, 18(4): 330-333. doi: 10.13374/j.issn1001-053x.1996.04.007

PDF( 323 KB)

Liquid Phase Sintered Molybdenum-Rich Copper Alloy

doi: 10.13374/j.issn1001-053x.1996.04.007

Department of Material Science and Engineering, USTB, Beijing 100083, PRC

Received Date: 1995-11-03
Available Online: 2021-11-13

Abstract

Abstract

Mo-rich Cu alloy was made with the method of liquid phase sintering the mixed Mo and Cu powder.The sintering property and structure were studied by means of TEM,SEM and EDXA.The results indicate as follows:as the result of Mo solution and reprecipitation,the medium of Mo-Cu changing in composition is formed on the surface of Mo particles,and the structure is homogeneous with fine Mo particles;the optimum sinter temperature is at which wetting angle is around zero.
- Mo-Cu alloy,
- liquid phase sinter,
- sintering property