Hot Metal Supply Impactd on Converter Layout

LIU Maolin; XU Anjun; WU Xiaodong; TIAN Naiyuan; LU Zhixin; SUN Guowei

doi:10.13374/j.issn1001-053x.2001.02.002

Volume 23 Issue 2

Aug. 2021

Turn off MathJax

Article Contents

Article Navigation > Chinese Journal of Engineering > 2001 > 23(2): 101-105

LIU Maolin, XU Anjun, WU Xiaodong, TIAN Naiyuan, LU Zhixin, SUN Guowei. Hot Metal Supply Impactd on Converter Layout[J]. Chinese Journal of Engineering, 2001, 23(2): 101-105. doi: 10.13374/j.issn1001-053x.2001.02.002

Citation:

LIU Maolin, XU Anjun, WU Xiaodong, TIAN Naiyuan, LU Zhixin, SUN Guowei. Hot Metal Supply Impactd on Converter Layout[J]. Chinese Journal of Engineering, 2001, 23(2): 101-105. doi: 10.13374/j.issn1001-053x.2001.02.002

Citation:

PDF( 575 KB)

Hot Metal Supply Impactd on Converter Layout

doi: 10.13374/j.issn1001-053x.2001.02.002

1. Metallurgy School, UST Beijing, Beijing 100083, China;
2. Production Department, Baosteel Group, Shanghai 200019, China

Received Date: 2000-09-01

Abstract

Abstract

The process time of hot metal ladle was measured and analyzed, and the neck of hot metal supply was pointed out when two or three converters are located in one line. The most annual capacity of one converter was calculated in different neck. The result is that three converters located in one line are not suitable for the production demand of fast converter In the meantime, anneal capacity is calculated, and the adaptability is discussed to the higher speed continuous casting about new converters layout in Japan. The references are provided for enterprise alteration in our country.
- converter,
- layout,
- production capacity